Machine Shop Details

Click images for enlarged view

Add realism to your model railroad with these industrial machines. Many kinds of machines are used to keep locomotives and other equipment running. Below is a selection appropriate in engine houses, back shops, and for on and off line industries.

Figures shown for scale only and are sold separately.

Also Check out the Berry Machine Shop. Wolfeborough, New Hampshire

Picture	Description	Price
	Acme-Gridley Bar Machine	$7.50
	Bridgeport Milling Machine	$4.75
	Brown and Sharpe Screw Machine	$4.75
	Cincinnati Horizontal Mill	$5.25
	Cincinnati Centerless Grinder	$4.75
	Cincinnati Pedestal Grinder	$4.75
	Cincinnati Vertical Mill	$5.25
	Five Drawer Filing Cabinets (pair)	$7.50
	Jones-Lamson Opticla Comparator	$6.25
	Long Bed Metal Planer Long stroke planer patterned after those produced by G.A. Gray, Liberty, Niles and others. Common in large machine and maintenance shops....Just like the one I used to watch on the night shift converting old railroad rail into bending dies for large sheet metal presses.	$18.50
	Factory Skids/boxes (set of 4)	$7.75
	Lincoln Welder, Stationairy	$7.50
	US Electrical Inc. Shop Buffing Machine	$7.75
	Shop table	$3.25
	Kearnery & Trecker Mill	$4.95
	Surface Grinder	$4.00
	Warner and Swasey Turret Lathe	$4.75
	Wheel Lathe Just like the one found in almost every major railroad repair shop.	$15.50
	Shop, Industrial Air Compressor	$4.50
	Bandsaw	$3.50
	Floor Drill Press	$2.50
	Radial Drill	$4.95
	Engine Lathe	$7.50
	Arbor Press	$1.25
	Floor Mounted Bending Brake If you are going to form metal for your cabs you will need a Bending Brake. (figure not included) Click to view rear of press	$15.00
	Five Ton Jib Crane For those heavy loads moving on or off trains or trucks. Kit snaps together in a minute. Chain Hoist and figure not included	$9.50
	Chain Hoist Hooks on both ends of hoist, made with real chain. Figure not included.	$5.25
Gear Load not included Available in Loads section	Gantry Crane This gantry crane model is created from an actual prototype erected in the 30's and still stands to this day. What's in the kit? Two cast resin parts for the concrete foundation. Laser cut parts for the crane structure and cast metal parts for the motor, hook, and control panel detail. Full assembly instructions and cable for the hook are also included. You will need small files, "super" glue, Pine Vise with a #61 Drill bit (.039") and modeling paints for assembly and finishing of the kit. The scenery, figures, vehicles and trees are not included. The large gears are not a part of this kit.	$28.95
	Fork Lift Truck You will need one of these to move things around in your Machine Shop.	$13.00